SPONSORED LINKS
At 11:59 AM 3/4/96 -0500, you wrote: >Mike, I think we are asking the same question. If you are running Windows >95, there is a file called DISPWIN.INI, and if you have selected the right >display type in Control Panel, Display, Settings, the file should contain >the parameters for the monitor. i.e. 800x600 72, 1024x768 75, etc. Mine >has it, but it still doesn't work. > >What I did was to create a file called SYNC.BAT, which contains >the PS2.EXE VSYNC 800x600 72 statement, and then put SYNC.BAT in the RUN= >statement in win.ini. > >It's klugy, but it works... Richard, Yes... you're right. We're asking the same question really. I'd come to the same kludgy solution that you have, but I think my question/difficulty goes a bit beyond yours. What monitor do you use with your 760? I've got an NEC 3FGe lashed to the 755cx and it really is a nice unit, but using the CX's display adapter, the monitor's image shifts from one side of the tube to the other depending on SYNC settings; (ie: If I adjust the monitor's 800x600x72Hz display to center, the image will be off center as soon as I boot to DOS or use a different screen resolution.) It's not a horrendous problem because I grudgingly use Win95 99% of the time. However, I'd love to NOT have to retune the monitor each time I boot to DOS, or have to look at the '95 Logo off kilter every time I booth the machine. On my desktop, my old display/controller combination, (Viewsonic 15/Diamond Viper) worked well, because the controller could be pre-tuned for each setting such that the picture would re-center itself if resolution or sync rates were altered. Any ideas? -Michael PS: I still love this machine. Thanks again. --- Michael Klenner East: klennerm@is.nyu.edu New York University West: mklenner@pacificnet.net Tisch School of the Arts http://pages.nyu.edu/~mdk1143 Institute of Film & Television talk: michael@24frames.com ---