SPONSORED LINKS
> I had the same problem with my 765d. I fixed it by the following: > Remove the serial port from the device manager. Reboot and go into the > bios setup and initialize the thinkpad. Reboot and that should do it. > You will need to reset all your other options when you do this. I'm running Warp 4 on my 40M 755 CDV. After upgrading to FP5 and to Mwave 2.24, I have the following problem; - When using COM.SYS in config.sys my system does not recognize COM2; when issuing MODE COM2, it says it is not installed; when issing MODE COM1, the system traps - When using COM.SYS (1,3f8,4) (2,2f8,3), everything is good BUT FaxWorks Pro does only recognize COM1 and so is unable to send or receive :-( Also the hardware manager show 2 (two) serial COM ports installed - When using SIO.SYS, everything is also good, but FaxWorks still does not work and the hardware manager show 1 (one) serial SIO port installed I have tried a lot of things (including having my whole system checked and repaired by IBM) but this "feature" remains. Should I consider reinstalling FaxWorks ? Or should I try to use the above procedure ? Thanks for help Francois 02/14/98 13:47:42 Francois Hurter CompuServe: 100041,1117 Internet: abacab@swissonline.ch