SPONSORED LINKS
On Wed, 15 Apr 1998 00:58:25 -0700, Joe Suttle wrote: >Has anyone out there successfully installed Warp 4 on a 701C. Right here! Managed to >get all the right files unpacked off the CD and added to Disk 1, along >with the drivers for the portable CD. Install seemed to work ok, but >cannot get to parallel port or serial port on Replicator. When I FN-F1, >and look at the Multiport, it shows serial and parallel disabled. >Finally got parallel back, but only for printer. Parallel tape backup >fails. What backup solution are you trying to use? Also, that's unusual that serial and parallel would be blanked out. System has a Panasonic SCSI PC card for CD-Rom So you're trying to install by CD-ROM or floppy? I installled Warp 4 by floppy (and had to allocate 6 hours to do so). and IBM Home and >AWay Ethernet/Modem combo. RMVIEW shows that the two PC cards take over >irq 3 & 4, and even when I change the H&Away adapter in 'protocol.ini', >can't get the modem to work. System keeps giving me messages for all com >ports as not enabled! Any ideas out there? > Let me look at my config.sys on my ThinkPad and cut out a line for you - I've got my Home & Away set to COM3, IRQ11 so I can use the internal modem for faxes and the DB9 serial port for diagnostics. Did you get PCMCIA and video setup okay? -- Paul Khoury | <pkhoury@loop.com> | Sent from my P75 Server Proudly running OS/2 Warp 3/4, Slackware Linux, and Sun Solaris 2.4