README.TXT
-----------------------------------------------------------------------------

To install the files included in this diskette, follow the steps below.

Note: Before installation of the files included in this diskette,
      install the Windows 95 USB module and 'System Update Disk' module.
      About installation of the USB module, refer to "Restoring the
      Windows 95 system" section in your machine's User's manual.
      About installation of 'System Update Disk' module,
      refer to readme.txt in 'System Update Disk' that you made according to
      instructions in the Backing up utilities and drivers section in your
      machine's User's Manual.

1. Click on Start button in taskbar at the bottom of your screen.

2. Select "Shut Down" at pull down menu.

3. Select "Restart the computer in MS-DOS mode?" and click on Yes button.

4. After the machine reboots into MS-DOS mode, make sure that
   'Toshiba Special Enhancement Disk (TSED)' (this diskette) is
   in the floppy disk drive and type the following:

     a:setup

   and hit Enter key.

5. After setup, type exit and hit Enter key.

6. Windows95 will restart.

7. After restart, click on Start button in taskbar at the bottom
   of your screen.

8. Select "Programs" at pull down menu.

9. Click "Windows Explorer" at pull down menu.

10. Click 3 1/2 Floppy Drive (A:) at All Folders window.

11. Put the pointer on Zvmask icon at Contents of '3 1/2 Floppy Drive (A:)'
    window of Exploring window and click secondary button.

12. Select "Install" at pull down menu. Copying Files... window is displayed.

13. After setup, remove the diskette from floppy disk drive.

14. Click on Start button in taskbar at the bottom of your screen.

15. Select "Shut Down" at pull down menu.

16. Select "Restart the computer?" and click on Yes button.

17. Windows95 will restart.

18. Put the pointer on My Computer icon of the desk top and
    click the secondary button to display a pull down menu.

19. Select "Properties" at the menu. System Properties window
    will appear.

20. Click Device Manager tab and double click Monitor icon.

21. Select Plug and Play Monitor icon and click on Remove button.
    Confirm Device Removal window will appear, then click on OK button.

22. Select View devices by connection on Device Manager tab.

23. Double click Plug and Play BIOS icon.

24. Click PCI bus icon and click on Remove button.
    Confirm Device Removal window will appear, then click on OK button.

25. System Settings Change windows will appear, then click on Yes button.

26. Windows95 will restart.

27. If Version Conflict window is displayed, click on Yes button.

28. If Update Device Driver Wizard is displayed, insert appropriate
    driver disk that you made according to instructions in the Backing
    up utilities and drivers section in your machine's User's Manual and
    click on Next> button and follow the on-screen directions.
    (In case of "PCI Communication Device", the driver is not need for it,
     so click on Next> button and click on Finish button.)