SPONSORED LINKS
I did check out the video out and that is working like normal. That definitely sounds pretty unusual, I have the DX4/100 version as well. I don't there could be any way of getting the picture of whats on the LCD screen in the video capture box of DVP without it being a hardware glitch. You could try cycling between the external CRT and LCD and disabling enhanced video and turning it back on, which might get something to click. On Tue, 15 Oct 1996, Michael Redmond wrote: > I tried this but couldn't make it work. It looks like the video-in kinda > keeps working, but the video-out stops. When I reverted to the 755CD EV 1.20 > install, the output started working again. Could there be something that you > did that got missed (or that I missed)? > > Something funny is going on with my video-in in both cases (755 and 760 > drivers) right now. Instead of getting external video in, I get > reproductions of the TP screen. Pretty wierd. This is while using Digital > Video Director Capture. I just got my TP back from IBM EasyServe. I hope > they didn't mess something up...but I don't know what it could have been if > they did...Direct video screen capture actually can be neat if it could be > better controlled. It looks a lot faster than ScreenCam or similar products. > Too bad it's just some system/software glitch. > > Thanks > Mike Redmond > > PS I have an "older" 755CD with the 486 DX4 processor, not the Pentium version. > -------------- > At 09:25 PM 9/21/96 -0400, you wrote: > >I tried out a hunch and downloaded the enhanced video drivers for win95 > >for the 760CD to try out on my 755CD. The video capture card on both of > >them is the V7320 so I figured they might work. And in fact they do, and > >it gives you an additional feature, an MCI overlay driver which you can > >use from win95 media player that gives you a video in window that you can > >resize dynamically by just clicking on the corners and stretching it. > >There is one caveat however, for some reason you must use your original > >V7320APM.EXE driver that is loaded in you config.sys, so before you > >install these drivers make a copy of v7320apm.exe under a different name > >then copy it back. If you use the one that comes with the 760cd disk, > >then the video input window will not work after resuming from suspend > >mode if it was open when you went into suspend mode. > >The file to get from the IBM ftp site is vetpfw95.exe. > >Perhaps if someone from IBM is reading this they could change the files on > >the ftp site so that at least the mci overlay driver is included with > >755cd dtiver diskette. > > > >The changes the vetpfw95.exe file will make to your config files are as > >follows: > > > >config.sys: > >replaces v7320apm.exe and v7320mgr.exe > > > >system.ini: > >in [boot] on drivers= adds c:\v7320\v7320pnl.dll > > > >in [386enh] replaces v7320.386 with new version > >in [drivers] replaces v7320cap.drv and v7320rdr.drv with .dll versions > >in [MCI] ads Overlay=v7320ovl.dll > > > > > >Remember for it to work properly (this was my experience) with > >suspend/resume you must use your old v7320apm.exe in config.sys, all the > >other files you can let it overwrite. > > > >Josh Hosseinof > >hosseino@yu1.yu.edu > > > > > > > > > > > > >