SPONSORED LINKS
Thanks for the advice. I have WinJammer (eval), and even with the Audio Control set properly, I couldn't get anything to go out to the MIDI port. However, thanks to your advice, I was able to turn on MIDI port input in Audio Control, and surprisingly enough, I was able to read the keyboard into WinJammer. So, that must mean the drivers and most of the hardware actually works. I am now focusing on hardware problems with the cable or motherboard for just the MIDI out circuit. Maybe a broken wire or bad solder connect. So much for quality control. The fact that IBM supplies no diagnostic for the MIDI/Gameport sure causes major difficulties in diagnosing these problems. There is still a remote chance that there is some obscure resource conflict in the drivers, but I am almost to the point of rejecting that since there are no error messages anywhere. Thanks again! Mike Redmond ---------------- At 01:34 PM 9/15/96 -0400, you wrote: >I use my 755CD with a Cakewalk and several synths and it works just fine. > >If the Mwave driver is installed correctly, just > >goto /Control Panel/Multimedia/MIDI and >select "MIDI for IBM Mwave MidiPort Device" > >Make sure that in Mwave Audio Mixer (Audio Control) MIDI isn't muted > >Hardware: ThinkPad Gameport connector and generic Gameport to MIDI interface. > >Regards, >-Alan >