SPONSORED LINKS
Hi Alexander, On Sun, 29 Mar 98 11:49:39 -0100, Alexander Wagner wrote: >- Warp 4 works fine. But if I boot up a fullscreen commandline >(ALT-F1 -> F2) the screen get's crippled. I've two cursors and the >lines are displayed twice. Fullscreen Session works fine if I boot up >PM-Mode. (Than of course the TP-drivers are loaded.) So far one would >suggest: Problem in OS/2-VGA-devices. The strange thing is: That >works all fine, if I boot up from the istall disks. I checkt with >Warp 3 and Warp 4. Any hints? Checked for the 640x480 with 16 Colors and (only) 60 Hz video mode setting? AFAIR Warp's VGA driver can only use the video chip in VGA mode with the above settings. >- Cause I've no external cover for the diskdrive I'd like to use the >hotswap in the Ultrabay. If I specify /A:0 /FORCE:1 /U:0 /F:1.44MB to >IBM1FLPY and /A:1 /U:0 /ATAPI /FORCE to IBM1S506 as said in the docs >I've to reinstall my system cause the whole filesystem on the HDD >crashes. On can't repair it as far as I tried. (OS/2 boots up with >about 20 SYS-Errors reading CONFIG.SYS). Any hints about that? Do you use a 2nd HDD in your ultrabay which has at least one primary partition on it?! If yes and your Warp partition on your built in (1st) HDD is placed on a logical partition, drive letters getting change which confuses Warp because it saves drive letter name in *INI files, etc. >And then a short silly question: What's the diffrence between >Hibernation and RediSafe-Suspend? Both suspend to disk, RediSafe is >faster, both switch off power completely as far as I see. So what's >the diffrence? RTOLH (ReadTheOnLineHelp :-)